61
OS32C
User’s Manual
Chapter3
Basic Operation of Configuration Software
E
Copy & Paste a Zone Set
To copy and paste a zone set (a safety zone and its corresponding two warning zones):
1. Select the destination zone number (bring to foreground).
2. While holding down the Ctrl key, use the left mouse button to drag and drop the desired zone set from
the Defined Zones tab, onto the destination zone.
Fig. 3-43 Drag and drop
In the above figure, zone set 2 is to be copied to zone set 1.
This method of drag and drop to copy and paste zone sets can also be used to copy and paste single zones (safety or
warning).
To Next Page
Loading...
