Omron VARISPEED F7 User Manual

6-142
6
Writing Parameter Set Values Stored in the Digital Operator to the Inverter (COPY)
To write parameter set values stored in the Digital Operator to the Inverter, use the following method.
If an fault is displayed, set the parameters again. Refer to page 7-18, Digital Operator Copy Function Faults
for corrective actions.
Step
No.
Explanation Digital Operator Display
1 Press the MENU Key and select advanced programming mode.
2 Press the DATA/ENTER Key.
3
Press the Increment and Decrement Key until parameter o3-01 is displayed
(Copy Function Selection).
4 Press the DATA/ENTER Key and select the constants setting display.
5 Change the set value to 2 using the Increment Key.
6
Set the changed data using the DATA/ENTER Key. The COPY function will
start.
7
If the COPY function ends normally, “End” is displayed on the Digital Opera-
tor.
8 The display returns to o3-01 when a key is pressed.
** Main Menu **
-ADV-
Programming
Initialization
-ADV-
A1
- 00 = 1
Select Language
COPY Function
-ADV-
o3 - 01 = 0
Copy Funtion Sel
Copy Function Sel
-ADV-
o3-01= 0
COPY SELECT
*0*
Copy Function Sel
-ADV-
o3-01= 2
OP INV WRITE
*0*
COPY
-ADV-
OP INV
COPYING
COPY
-ADV-
COPY COMPLETE
Copy Function Sel
-ADV-
o3
-
01 =0
COPY SELECT
*0*

Omron VARISPEED F7 Specifications

General

Brand	Omron
Model	VARISPEED F7
Category	Inverter
Language	English