Image name defines the base filename for image segments. The default value is
image. Tap the Image name text area to change the filename, then select a File
format and File size.
Compression is enabled by default for ex01 and e01 file formats but can be
disabled if desired. Compression is not supported for dd and dmg file formats.
Note: DMG files that were created from non-512 byte sector source media
will not open on Apple devices by default. A special command line
workaround is required when attempting to open such DMG files on an
Apple device. TX1 will provide a warning in the Image Settings area when
this condition is detected and DMG is selected as the file format.
8. Once you are satisfied with your settings and drive selection, tap the Start
Duplication button. A Job Status screen is automatically displayed, as shown
below.
Chapter 4 Using TX1
84
OpenText™ Tableau™ Forensic TX1 Imager
ISTX240300-UGD-EN-1
To Next Page
Loading...
