Note: TX1 remote user interface has been validated for use with the following
web browsers: Chrome (v86.0.4240.75), Firefox (v81.0.2), and Safari (v13.2.1).
Older and newer versions of these browsers and even other browsers may
work fine but have not been validated at this time.
4.12.2 Accessing TX1 remotely
To access TX1 remotely, a valid username and password are required. The user
account must also have remote access enabled.
To access a TX1 remotely:
1. On the User Management screen, confirm the user is set up on the system with a
password and remote access is enabled. In the example below, default user
User1 is shown. Before enabling remote access, a password must be added by
tapping the Add Password button. Once a password has been entered, toggle
the Allow Remote switch, as shown below.
2. Connect TX1 to your local area network with an Ethernet cable.
3. Obtain the assigned IP address from the side navigation menu, as shown below.
4.12. Remote web interface
ISTX240300-UGD-EN-1
User Guide
193
To Next Page
Loading...
