Install the eUSB Drive
See “Remove a Memory Riser” on page 98.
3.
Loosen the screw that attaches the eUSB drive to the motherboard.
Retain the screw to use with the new eUSB drive.
4.
Lift the eUSB drive up to disconnect it from the motherboard.
5.
Install a new eUSB drive.
See “Install the eUSB Drive” on page 116.
Related Information
■
“Install the eUSB Drive” on page 116
Install the eUSB Drive
This is a cold-service procedure that can be performed by a customer. Power down the server
completely before performing this procedure.
116 SPARC T8-2 Server Service Manual • June 2019
To Next Page
Loading...
