Install a Drive
3.
Install a drive or a replacement drive filler.
See “Install a Drive Filler” on page 72 or “Install a Drive” on page 70.
Related Information
■
“Determine Which Drive Is Faulty” on page 65
■
“Remove a Drive” on page 65
■
“Install a Drive” on page 70
■
“Install a Drive Filler” on page 72
■
“Verify a Drive” on page 73
Install a Drive
Installing a drive into a server is a two-step process. You must first install the drive into the
drive slot and then configure that drive to the server.
Note - If you removed an existing drive from a slot in the server, you must install the
replacement drive in the same slot as the drive that was removed. Drives are physically
addressed according to the slot in which they are installed.
1.
Take the necessary ESD precautions.
See “Prevent ESD Damage” on page 55.
2.
Fully open the release lever on the drive.
70 SPARC T8-2 Server Service Manual • June 2019
To Next Page
Loading...
Need help?
General