Oracle SPARC T8-2 User Manual

Disconnect Power Cords
Disconnect Power Cords
Remove the power cords from the server only after powering off the server.
Unplug all power cords from the server.
Caution - Because 3.3V standby power is always present in the server, you must unplug the
power cords before accessing any cold-serviceable components.
Related Information
■
“Power Off the Server (Oracle ILOM)” on page 52
■
“Power Off the Server (Server Power Button - Graceful)” on page 53
■
“Power Off the Server (Emergency Shutdown)” on page 53
■
“Rear Panel Components (Service)” on page 15
Related Information
■
“Safety Information” on page 45
Accessing Server Components
These topics explain how to access components on the outside and the inside of the server.
Perform these tasks in this order, as needed.
■
“Prevent ESD Damage” on page 55
■
“Extend the Server to the Service Position” on page 55
■
“Release the CMA” on page 57
■
“Remove the Server From the Rack” on page 59
■
“Remove the Top Cover” on page 60
Related Information
■
“Safety Information” on page 45
54 SPARC T8-2 Server Service Manual • June 2019

Oracle SPARC T8-2 Specifications

General

Brand	Oracle
Model	SPARC T8-2
Category	Server
Language	English