Oracle SPARC T8-2 - Oracle ILOM Properties that Affect POST Behavior

Configure POST
Refer to the section on setting the SPARC host keyswitch state in the Oracle ILOM
Administrator’s Guide for Configuration and Maintenance Firmware Release 4.0.x for a
description of parameters and values.
4.
View the current values for settings.
For example:
-> show /HOST/diag
/HOST/diag
Targets:
Properties:
default_level = off
default_verbosity = normal
error_level = max
error_verbosity = normal
hw_change_level = max
hw_change_verbosity = normal
Commands:
cd
set
show
->
Related Information
■
“POST Overview” on page 40
■
“Oracle ILOM Properties That Affect POST Behavior” on page 42
Oracle ILOM Properties That Affect POST
Behavior
There are a number of Oracle ILOM commands that you can use to perform host diagnostic
tests. For details about using these commands, refer to the chapter that describes configuring
host server management actions in the Oracle ILOM Administrator's Guide for Configuration
and Maintenance Firmware Release 4.0.x.
42 SPARC T8-2 Server Service Manual • June 2019