Servicing the Battery
The battery is located inside the chassis. See “Motherboard Component Locations” on page 19.
The battery maintains system time when the server is powered off and disconnected from AC
power. If the show faulty or fmadm faulty commands indicate a battery failure, replace the
battery.
Caution - Ensure that all power is removed from the server before removing or installing
the battery. You must disconnect the power cords from the server before performing these
procedures.
■
“Replace the Battery” on page 111
Related Information
■
“Detecting and Managing Faults” on page 27
■
“Preparing for Service” on page 45
■
“Disconnect Power Cords” on page 54
Replace the Battery
1.
Prepare the host for battery replacement.
To correctly reset the date and time before replacing a battery, you must revent the host from
automatically powering on and disable any NTP connections.
a.
Check the HOST_AUTO_POWER_ON property.
-> show /SP/policy HOST_AUTO_POWER_ON
Properties:
HOST_AUTO_POWER_ON = enabled
b.
If enabled, set the HOST_AUTO_POWER_ON property to disabled.
-> set /SP/policy HOST_AUTO_POWER_ON=disabled
Servicing the Battery 111
To Next Page
Loading...
Need help?
General