Servicing the SPM
These topics describe how to service the SPM module.
■
“SPM Firmware and Configuration” on page 129
■
“Remove the SPM” on page 130
■
“Install the SPM” on page 131
■
“Verify the SPM” on page 134
SPM Firmware and Configuration
System firmware consists of two components, an SPM component and a host component. The
SPM firmware component is located on the SPM, and the host component is located on the
motherboard. For the server to operate correctly, the firmware in these two components must be
compatible.
When replacing the SPM, you must restore the configuration settings maintained in the SPM.
Before replacing the SPM, save the configuration using the Oracle ILOM backup utility. Refer
to the Oracle ILOM documentation for instructions on backing up and restoring the Oracle
ILOM configuration.
After replacing the SPM, the new SPM firmware component and the existing host
firmware component must be consistent with each other. To ensure that the firmware is
compatible throughout the server, load new system firmware as described in “Install the
SPM” on page 131.
Related Information
■
Oracle ILOM documentation in http://www.oracle.com/goto/ilom/docs
■
“Servicing the Motherboard” on page 147
■
“Remove the SPM” on page 130
■
“Install the SPM” on page 131
Servicing the SPM 129
To Next Page
Loading...
Need help?
General