Oracle SPARC T8-2 - Verify the Drive Backplane

Verify the Drive Backplane
9.
Verify that the component was successfully installed.
See “Verify the Drive Backplane” on page 163.
Related Information
■
“Remove the Drive Backplane” on page 159
■
“Verify the Drive Backplane” on page 163
Verify the Drive Backplane
1.
At the Oracle ILOM prompt, start the fault management shell.
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y

faultmgmtsp>
2.
Type fmadm faulty to check for faults.
■ If faults are reported, see “Detecting and Managing Faults” on page 27 .
■ If no faults are reported, then the drive backplane has been replaced
successfully.
Related Information
■
“Remove the Drive Backplane” on page 159
■
“Install the Drive Backplane” on page 160
Servicing the Drive Backplane 163