Remove the Fan Board
5.
Loosen the three captive screws connecting the front memory riser guide to
the motherboard, and remove the two screws on each side of the outside of the
chassis that hold the fan board in place (panel 1).
6.
Carefully unplug the fan board cable and the power cable from motherboard
(panel 1).
Caution - When removing the ribbon cable from the motherboard, grasp the cable connector on
either side and pull straight up to disconnect the cable. Do not rock the cable side to side. Doing
so could damage the connector.
Save the cables for use with the new fan board.
7.
Remove the front memory riser guide by pulling it up and out of the chassis
(panel 2).
138 SPARC T8-2 Server Service Manual • June 2019
To Next Page
Loading...
