Oracle SPARC T8-2 - Page 44

Clear a Fault Manually
faultmgmtsp> exit
-> reset /System
Are you sure you want to reset /System? y
Resetting /System ...
6.
Clear the fault in the Oracle Enterprise Manager Ops Center software, if
applicable.
Clearing a fault with the fmadm aquit command does not clear that fault in the Oracle
Enterprise Manager Ops Center software. You must manually clear the fault or incident. For
more information, refer to the section on marking an incident repaired in the Oracle Enterprise
Manager Ops Center Feature Reference Guide at:
http://www.oracle.com/pls/topic/lookup?ctx=oc122
7.
If you are servicing a component, return to the procedure for that component.
Related Information
■
“Checking for Faults” on page 27
■
“Interpreting LEDs” on page 33
■
“Performing Advanced Troubleshooting” on page 37
44 SPARC T8-2 Server Service Manual • June 2019