1. Before use
- 8 -
4) Using to hang a strong Slope that meets the standard on a gentle slope (15 degrees or
less), reduce the engine speed, load "forward", and unload "backward" slowly at low
speed.
5) When transporting, secure it with a strong rope. Also, please try to drive safely.
1.5 Inspection・Maintenance
◎Regular inspections are essential to maintain quality and performance.
〈Please note that we are not responsible for any accidents or malfunctions caused
by neglecting regular inspections.〉
Lack of follow the instructions below may result in burns, injury or mechanical failure.
1) Before and after use, perform daily inspections and maintenance, as well as regular
inspections and maintenance to always keep the product safe and comfortable.
2) For inspection, adjustment, and maintenance, stop the engine, and after the muffler and
other overheated parts of the mission case have completely cooled, then wear protective
gear such as leather gloves and protective goggles, and using appropriate tools.
3) Perform the inspections, adjustments, and maintenance on a flat, hard, wide and bright
place, always pay attention to the balance of the Machine, and be careful not to tip it
over.
4) Be sure to prevent the machine from falling when you lift it for inspection.
5) When replacing or attaching / detaching the working part (Blade) or driving part (Tire /
Crawler), make sure that it is securely attached to the specified location and that it is
firmly tightened.
6) When replacing the working part (Blade) or driving part (Tire / Crawler) to a new one,
replace the setting bolts with a new one for safety.
7) It is dangerous to damage the safety cover of the Belt and Blade, and the shatterproof
cover. Do not leave the part where you feel an abnormality during the work,
but be sure to interrupt the work and inspect it, and after the work is completed, inspect
it again and make necessary repairs.
8) Install the removed cover correctly in its original position.
9) Never attach or modify any attachments other than those specified.
10) If the fuel hose becomes old, it may cause fuel leakage and is dangerous.
Replace it with a new one every 3 years or when it is damaged with a tightening band.
To Next Page
Loading...
