OREC RM983 - How to Stop the Engine; How to Drive. Speed Shift; How to Drive; Turn. Stop

4.運転・作業のしかた
- 23 -
When the engine switch is set to the "START" position, a large current flows through the
starter motor, so avoid continuous use for more than 5 seconds.
If it does not start within 5 seconds, return the engine switch to the "stop" position, pause
for 10 seconds, or more, and then repeat the same operation.
Do not put the engine switch in the "start" position while the engine is running. It may cause
a cell motor failure. If the engine is warm enough, start the throttle lever in the "medium
speed" position. (It does not necessarily have to be in the choke "closed" position)
For safety, be sure to "lock" (park) the parking brake pedal with the brake stopper during
warm-up operation.
4.1.2 How to stop the engine
① Move the throttle lever toward the "low speed" position.
② After a few seconds in the low speed position, turn the key
to the "OFF" position and stop the engine.
③ Remove the key from the engine switch.
④ Finally, put the fuel cock in the "closed" position.
4.2 How to drive. Speed shift. Turn. Stop
Do not use by unskilled persons (other than the owner) regarding safe work and operation methods.
When operating the first time, check the safety of the surroundings, and practice thoroughly on a flat
place with no obstacles and at low speed until you become accustomed to the operation and features
of the product.
4.2.1 How to Drive
① Start the engine.
② Move the throttle lever to the "high speed" side to
increase the engine speed.
Throttle Lever