3.作業前の点検
- 18 -
３. Inspection before work
●Before starting work, check "1.2 Before work", and check the "Pre-start checklist"
below and Be sure to perform the pre-start inspection according to "7.1 Periodic
inspection table".
※If you have any questions or concerns, please be sure to contact the store where you
purchased the product.
1) Be sure to stop the engine before performing inspections, refueling, adjustments, and
maintenance.
2) Before starting the engine and checking the operation of the Driving clutch lever, etc.,
check the position of each lever and the safety of the surrounding area.
3) Carefully read the warning mark on the machine.
3.1 Checking the Engine oil
① Level the machine and
remove the oil gauge.
② The tip of the filler tap is an
oil gauge. Wipe the gauge part
with a cloth, level the engine,
screw in the filler plug for the
Briggs engine,
insert it without screwing in the Kawasaki engine, Check the amount of oil.
If there is no oil between the upper and lower scale lines, replenish the engine oil so that
the oil reaches the upper scale line.
<Refer to 5. Inspection / Maintenance>
"1" Loose bolts and nuts, Fall off
"2" Deformation, Wear, Interference
"3" Moves smoothly or sticks
"4" Remove foreign substances such as dust,
grass and straw
To Next Page
