1. Before use
- 4 -
3) Remove stones and other foreign substances in advance, and if there are obstacles that
cannot be removed, install a caution sign or a safety fence indicating the work
prohibition range before starting work. Also, for safety, work at a higher mowing than
usual in such fields.
4) Remove objects such as rocks and metal that may cause sparks due to contact with the
blade in advance. If it cannot be removed, make a prominent mark to keep it away.
5) When mowing dead grass, clean the engine and the area around the exhaust pipe,
which become hot, once an hour to check for the accumulation of grass debris.
6) Dead grass may catch fire due to spontaneous combustion or external fire. When cutting
dead grass, have a work manager other than the worker and always monitor it.
7) Take especially careful when mowing during a dryness warning is issued, and do not
mow in some cases.
8) To prevent falls, when driving on rivers, cliffs or steps (shoulders), consider the risk of
road shoulder collapses and falls, and drive on sufficiently safe flat terrain.
9) It is dangerous to use it in the dark or when visibility is poor. Do not use it when you
cannot fully understand the surrounding conditions. The light attached to this unit is for
moving. Never use it for night work.
1) Avoid using the product under conditions such as rainy weather or puddles where the
unit is exposed to a large amount of water.
2) Please decide on work implementation while paying attention to other weather
conditions.
1.2.２ Inspection / confirmation before work
1) Never start the work until the repair is completed for the parts requiring repair, etc. that
were confirmed after the previous work was completed.
2) It is extremely dangerous to operate with the standard safety device and related parts
removed, as well as the safety covers. Check the normal condition before starting work.
3) When the work clutch (knife clutch, etc.) is in the "off" position, check that the V-belt is
securely stopped, and if it is moving even a little, stop the engine, adjust the belt
stopper and the wire.
4) It is dangerous for the Blade to fall off. Tighten the set bolts and nuts of the Blade. Also,
replace the old one with a new one.
5) If there is an open / close cover for replacing the Blades, it is dangerous to use it while
it is open. Be sure to use it in the closed state.
To Next Page
Loading...
