5. 点検・整備・調整
- 47 -
The front wheel rubber cover prevents the grass from rolling
up anddust from entering, but please remove the front wheel
Regulary for inspecting and cleaning.
Please lift the front with a jack referring to the photo on the
left. When lifting, please do so on a flat surface with the
parking brake applied.
① Remove the wheel cap, split pin and nut, and remove the
tire. When assembling after inspection and cleaning, do
not reuse the split pin, use a new one. Tighten the nut by
setting the hole for the split pin.
② Clean the inside of the tire whee. When assembling, grease
up and lubricate the kingpin shaft.
5.4 Knife inspection / replacement / installation
■For safety, please inspect the knife and knife stay before work.■
1) Since a sharp knife is used in this machine, be sure to use the "knife replacement tool"
that comes with the product when attaching or detaching the knife during inspection or
replacement. Never touch the knife directly with your bare hands using gloves.
There is a risk of injury.
2) Please specify all parts required for knife replacement, including knife stays, as genuine
manufacturer's products.
To Next Page
Loading...
