4.3 Loading and unloading and transportation
When transporting this machine, be sure to stop the engine and put the fuel cock in the
"closed" state.
Fuel leaks can ignite spilled fuel. Also, do not tilt the unit more than necessary. Fuel may
leak
1) Be sure to use a bridge. Hanging and unloading this product (using a UNIC vehicle, etc.)
not only causes problems such as frame deformation, but is also extremely dangerous
because it may fall. Please never do it.
2) Do not stop in the middle of the bridge. Especially in the case of rear load, the front wheels
may rise when restarting, which is dangerous. Please load and unload at a low speed at
once.
3) The truck to be used should have no ceiling (hood) on the loading platform. When loading
and unloading, there is a risk of collision with workers depending on the height of the
ceiling.
4) Choose a flat and stable place and do not do it on public roads.
5) The truck to be used should be able to withstand the total weight of this product
and the total weight of the driver.
6) If you work with more than one person, please decide in advance a signal with the truck
driver to prevent accidents.
7) Do not load or unload at night. If it is unavoidable, work in a place where sufficient lighting
is available.
8) For trucks, stop the engine, pull the side brakes and chock the tires.
9) Be sure to set the cutting height adjustment lever to the "move" position. The knife may
come in contact with the bridge and tip over.
10) Be sure to set the diff lock lever to the "ON" position and do not operate it on the bridge.
11) Make sure that the hook of the bridge is hooked on the truck bed so that there is no step
and it does not come off.
12) Make sure that the left and right tires of this product are located in the center of the
bridge.
13) The engine should be stopped on the loading platform, the fuel cock should be "closed",
and the key should be removed. Use a rope that is strong enough to securely fix this
product on the loading platform.
To Next Page
Loading...
