2.各部の名称とはたらき
- 16 -
⑭Fuse BOX
Protects harnesses and electrical components in the event of overcurrent. There are 10A
(accessory) and 20A (charging) fuses, and a separate 20A fuse is included as a spare.
If the fuse blows, be sure to eliminate the cause and replace it with a spare fuse. Also, use
the spare fuse only for emergencies and immediately replace it with a regular A (ampere)
fuse.
⑮12V power socket
A power supply for accessories with a waterproof cap. 12V (maximum current: up to 10A in total)
Be sure to close the waterproof cap when not using the accessory power supply, as it may
cause a short circuit or dust that may cause ignition.
⑯Engine oil warning light (Red)
The engine switch is in the "Run" position and is lighting when the engine is stopped, but off
while the engine is running. If it is lighting when the engine is running, it means that the
engine is out of oil. Stop the engine immediately, check the amount of oil, and add the proper
amount.
⑰Pilot lamp (green)
Lights when the engine switch is in the "run" position.
⑱Hour counter meter
Approximate usage time is measured and displayed.
Please use it as a guide for maintenance time.
⑲Deck cleaning pipe
It is used to clean the inside of the safety cover of the knife
part.
By connecting a hose to the pipe, starting the engine while
running water, and turning the knife clutch lever "on", there is a
function to remove dirt inside the safety cover.
Reference;
1) The deck cleaning function with running water is only an auxiliary role to remove dirt
inside the safety cover.
2) It is effective to use it after work and before the dirt inside the safety cover dries. Dirt
that has dried and hardened cannot be removed.
3) If the dirt does not come off even after using it for about 3 minutes, wash it off with a
high-pressure washer.