2.各部の名称とはたらき
- 15 -
Be sure to close the knife cover during work. Mowing work with the cover open is extremely
dangerous because it causes an increase in the scattering of foreign substances such as
stones. Make sure that the knife cover is closed and locked except when inspecting or
replacing the knife.
⑫Seat (with seat slide and seat suspension function)
Adjust the seat slide back and forth by raising the seat slide lever in front of the seat. The
suspension can adjust the strength of the spring force according to the weight of the operator
by using the "suspension adjustment bolt" in front of the seat in the left photo. Turn clockwise
to make it stronger, and turn it counterclockwise to make it weaker. After starting the engine,
if the cutting height adjustment lever is not in the "move" position and the parking brake
pedal is not in the "lock" position, the engine will stop for safety when operaete leave the
seat . However, the pilot lamp does not go out and the key switch is in the "ON (operation)"
state.
If the engine stops, immediately turn the engine switch "OFF" or restart the engine.
If the engine is stopped for a while, the battery may be exhausted.
⑬Handle tilt lock lever
The angle of the handle can be adjusted according to the physique of the worker. With the
lock lever loosened, tighten it at the desired position to lock it. The lever becomes free
when pulled up. After deciding the handle angle, you can fix it at your favorite position.
Do not tilt the steering wheel while driving as it is dangerous.
To Next Page
Loading...
