Reference；
Be sure to use the engine switch to stop the engine. If you "lock" the parking brake and set
the cutting height adjustment lever to the "move" position, the engine will not stop even if
you stand up from the seat, but if you stand up from the seat in any other position, the
engine will stop for safety (The pilot lamp does not go out and the engine switch is in the
"RUN" state). In this case, if you leave it , the battery may be run down. Be sure to return
the parking brake and cutting height adjustment lever to the moving position, and return the
key to the "OFF" position. After starting the engine, the engine will not stop if you sit in the
seat regardless of the position of the parking brake pedal and the cutting height adjustment
lever.
4.2.3 How to operate the diff-lock lever
Use diff-locks only when loading and unloading, working on gentle slopes, in soft ground,
and when one of the rear wheels slips and it is difficult to go straight. When using other
than the above, be sure to return the diff-lock lever to the "OFF" position. If you use a diff
lock on a flat ground, not only will the inner tire be dragged when turning and the turning
radius will increase, but also each part of the main body (especially inside the mission) will
be overloaded, such as tire unevenness, which may cause a malfunction.
① Normally leave it in the "off" position. Only when a diff lock
is required on a muddy or steep slope, put the lever in the
"on" position and hook it into the notch to "lock" it.
② After escaping from muddy water, be sure to return the
diff-lock lever to the "off" position.
4.2.4 How to move when you cannot drive
On flat ground, setting the Sub change shift lever to the
neutral "N" position makes it easier to push the car
without starting the engine.
Used in case of engine trouble etc.
1) Always put the Sub change shift lever in the "mowing work" position or "move" position
except when pushing without Engine power.
2) For safety, please be sure to perform push with 2 people or more.
3) Do not set the Sub Change shift lever to the neutral "N" position on slopes. as it may cause slipping.
To Next Page
Loading...
