3.作業前の点検
- 19 -
1) If you want to check the engine oil after running the engine, wait "about 5 minutes or
more" after the engine is stopped and check the cooling condition of the muffler and
the engine body.
2) Be sure to check the amount of engine oil before starting, as deficiency of engine oil
may cause a malfunction.
3) The engine oil should be high quality SF / SG / SH / SJ grade or higher, use "10W-30"
oil, and do not use commercially additives.
4) After refilling, be sure to tighten the oil gauge. Loose tightening may cause engine oil
to leak out.
「Recommended oil」
3.2 Fuel inspection and refueling
① Level the machine, remove the fuel tank cap, and check
the amount of fuel from the refueling port.
② Refuel as soon as the fuel gauge approaches the "E"
position.〈Fuel: Unleaded regular gasoline—14 Litter 〉
③ Do not put fuel above the middle of the filter
(Fuel level upper limit mark) It may cause fuel leakage on
unevenness road surface and slopes.
The leaked fuel is discharged to the bottom of this unit
through the fuel drain hose. However, wipe off any
spilled fuel.
④ After refueling, be sure to tighten the fuel tank cap.
※The fuel gauge is a guide. Fuel should be in the middle
of the filter and be careful not to overfill and spill fuel.
To Next Page
Loading...
