4.運転・作業のしかた
- 22 -
④ Set the knife clutch lever to the "off" position and the
cutting height adjustment lever to the "move" position.
Reference；
The knife clutch lever is linked to the cutting height adjustment lever. When the cutting height
adjustment lever is moved to the "move" position, the knife clutch lever also returns to the "off"
position.
⑤ After confirming that the shift lever is in the neutral "N"
position, Pull the choke lever. （The state where the lever is
pulled is the "closed" position of the choke valve, and the state
where it is pushed is the "open" position.）(This operation is not
necessary if the engine is warm.)
⑥ Set the throttle lever to the middle position between the
"high speed" position and the "low speed" position.
⑦ Insert the key into the engine switch and turn the key
from the "run" position to the "start" position to start the
engine.
⑧ Release the key as soon as the engine starts.
Automatically returns to the "driving" position.
⑨ After starting the engine, push the choke lever back to
the "open" position, return the throttle lever to the "low
speed" position, and warm up for a while (about 5
minutes).
Reference；
Warming up distributes oil to each part of the engine, extending the life of the engine.
To Next Page
Loading...
