5. 点検・整備・調整
- 52 -
⑤ Thoroughly clean each part. In particular, cleanly remove grass and dust
accumulated near the rotating screen, exhaust system, air cleaner, muffler, HST fan
cover, carburetor and belt cover by air blowing, etc., and remove rust on the rust-
proof paint.
⑥ Grease and lubricate lubricated areas, respectively.
⑦ Apply the parking brake and store the unit horizontally in a well-ventilated and dry place
with a roof.
⑧ When covering the machine, make sure that each part of the engine has cooled down.
During storage, check the tire pressure regularly and inflate if necessary.
1) This product uses gasoline as fuel, and it is extremely dangerous because there is a risk
of fuel leaks during work, then cigarettes and bonfires are led to fire.
2) Work in a well-ventilated place, and store the machine horizontally on a hard and flat
place.
3) When draining the gasoline from the fuel tank or covering the machine, wait for the engine
and muffler to be cool down (about 5 minutes or more) after the engine is stopped.
4) When starting the engine and putting it in an "out of gas state", make sure that there are
no flammable materials in the vicinity, and then perform sufficient ventilation.
If you start work with grass or dust accumulated, the engine will overheat due to clogging
and grass dust, which may cause a burn or fire.
1) Long-term storage with fuel left in the fuel tank or carburetor may cause problems
such as start-up failure and output reduction.
2) For safety, remove the key and store it by the operator of this product.
3) Do not store the removed fuel in a plastic tank or use oxidized fuel that has been used for
more than 3 months as it may cause troubles.
4) Reinstall the removed hoses, clips, and drain bolts.
5) When cleaning the machine with water pressurized with a hose, etc., be careful to
cover the engine's electrical components, carbureter, air cleaner, and muffler exhaust
port so that water does not get on it. It may cause an engine start failure.
To Next Page
Loading...
