371
SEP 2006
Ver. 1.0
DP-8020E/8020P/8016P
(26) Install 2 Hinge Covers.
Note:
When installing the Hinge Covers, make sure that
a Hinge Film is placed inside of each Hinge Cover.
(27) Peel off 6 adhesive strip protectors from the
Scanning Pad.
(28) Place the Scanning Pad on the glass aligning it
on the upper left corner, keeping 1mm space as
illustrated.
Note:
Failure to install the Scanning Pad correctly may
cause a Black vertical, horizontal (or both) line(s)
to appear on the copies in the Double Exposure
Copy Mode. Upon completing the i-ADF
installation, verify that the Double Exposure
operation.
(29) Close the i-ADF.
Note:
Reopen the i-ADF Unit, and push the Scanning
Pad gently to glue it properly.
(30) Perform Service Mode F6 (No. 71, 72, 73, 90,
91, 92, 93, and 94) to adjust the i-ADF Scanning
Position.
To Next Page
Loading...
