Panasonic KX-TDA100 - Page 379

4.7 Configuration [1]
Feature Guide 379
Feature Guide References
None
Flash—Flash Signal Detection (TIE)
Enables the PBX to detect a hookswitch flash signal sent from a TIE line.
Default
Enable
Value Range
Disable, Enable
Programming Guide References
4.7.1 Slot [1-1]
Feature Guide References
None
Flash—Minimum BREAK Width (TIE)
Specifies the maximum length of the break signal in a flash signal sent from a TIE line.
Default
200 ms
Value Range
8 × n (n=3–63) ms
Programming Guide References
4.7.1 Slot [1-1]
Feature Guide References
None
Flash—Flash Width (TIE)
Specifies the maximum time required by the PBX to recognize a hookswitch flash signal sent from a TIE line.
Default
800 ms
Value Range
8 × n (n=3–191) ms
Programming Guide References
4.7.1 Slot [1-1]