Panasonic KX-TDA100 - Page 752

4.17 Maintenance [11]
752 Feature Guide
Default
CR+LF
Value Range
CR+LF, CR
Programming Guide References
None
Feature Guide References
1.23.1 Station Message Detail Recording (SMDR)
RS-232C: Word Length
Specifies the number of bits in each byte of a character.
When connecting the KX-TDA Maintenance Console to the PBX using an RS-232C cable, assign the
following values to the Serial Interface (RS-232C) port of the PBX:
Word Length: 8 bit, Parity Bit: None, Stop Bit: 1 bit
CAUTION
Do not use the following combinations:
• Word Length: 8 bit, Parity Bit: Space, Stop Bit: 1 bit
• Word Length: 8 bit, Parity Bit: Mark, Stop Bit: 2 bit
• Word Length: 8 bit, Parity Bit: Space, Stop Bit: 2 bit
Default
8 bit
Value Range
7 bit, 8 bit
Programming Guide References
None
Feature Guide References
1.23.1 Station Message Detail Recording (SMDR)
RS-232C: Parity Bit
Selects a parity bit code that indicates what type of parity is used to detect an error in the string of bits
composing a character.
Make an appropriate selection depending on the requirements of the printer or personal computer.
Default
None
Value Range
None, Mark, Space, Even, Odd