Parker PSD1-SW1200 - Page 45

192-011006N8 PSD1 Installation Guide
192-011006N8 2019-07 09.10.19 09:27 45 (109)
View from above (see page 47)
P10
Status LEDs for the fieldbus
C11
Slot for SD card
(SD card not included in delivery)
S12 (see page 38)
Device address higher value half-byte (accept with
power ON)
S13 (see page 38)
Device address low value half-byte (accept with
power ON)
P14 (see page 47)
Status LED axis 1
P15 (see page 47)
Status LED axis 2
P16 (see page 47)
Status LED axis 3
X17 (see page 49)
Digital inputs/outputs axis 1 & 3
X18 *
Feedback sensor Axis 1: Resolver (see page 55),
Encoder/Hall (see page 55)
X19 *
Feedback sensor Axis 2: Resolver (see page 55),
Encoder/Hall (see page 55)
X20 *
Feedback sensor Axis 3: Resolver (see page 55),
Encoder/Hall (see page 55)
S33
For safety option
S34
For safety option
X21 (see page 49)
Digital inputs/outputs axis 2 & 3
24 VDC & DC power (see
page 61)
Behind the yellow protective covers you can find the
rails for the supply voltage connection to the
mains
module PSD1-M_P
.
• 24 VDC power supply
•
DC power voltage supply
View from below (see page 46)
*
Before connecting a feedback cable, check that the correct feedback system is
configured in the device.
Otherwise, destruction of the feedback system is threatened by overvoltage!