Parker PSD1-SW1200 - P1: Status - Leds - Indication (Mains Module)

192-011006N8 PSD1 Installation Guide
192-011006N8 2019-07 09.10.19 09:27 59 (109)
5.12.1.2 View from below (PSD1-M mains module)
Front view (see page 57)
X40 (see page 64)
Brake resistor
X41 (see page 62)
Power supply
Central ground
connection
Connect ground via ring cable lug with a 10 mm
2
copper cable to central ground
5.12.2. P1: Status - LEDs - indication (Mains module)
P1 status
Green LED
a (left)
Red LED
b (right)
Status of the outputs
X4
24 VDC control voltage
missing or out of range
off
off
All Outputs = Low
Device ready
on
off
Ready A0 = high
Warning A1 = High
One or multiple errors
occurred
(Error number to be
displayed after 5 s)*
off
power on (5s)
Ready A0 = Low
Warning A1 = High
Intermediate circuit is
loaded, Control voltage OK,
Drive Healthy
flashes quickly
off
Ready A0 = Low
Warning A1 = High
Error digital outputs
off
flashes quickly
Ready A0 = Low
Warning A1 = High
Error over-temperature or
overloads
off
flashes slowly
Ready A0 = Low
Warning A1 = Low
Pre-warning active
on
flashes slowly
Ready A0 = high
Warning A1 = Low
Device in “bootloader"
status
flashes slowly
flashes slowly
All Outputs = Low
Waiting for release by input
0 = High (enable)
flashes slowly
off
Ready A0 = Low
Warning A1 = High