Parker PSD1-SW1200 - Introduction to Parker Servo Drives

192-011006N8 PSD1 Installation Guide
192-011006N8 2019-07 09.10.19 09:27 7 (109)
In this chapter you can read about:
• Device assignment ..................................................................................................................... 7
• Scope of delivery ........................................................................................................................ 7
• Type identification plate PSD1-S and PSD1-M with Safety Option Board ................................... 7
• Type identification plate PSD1-M ................................................................................................ 8
• Order/ type code PSD ................................................................................................................ 8
• Designated use .......................................................................................................................... 9
• Packaging, transport, storage ................................................................................................... 10
• For Safety Use ........................................................................................................................ 11
• Warranty conditions ................................................................................................................ 13
• Conditions of utilization ............................................................................................................. 13
• Before commissioning the drive, please observe the following: ................................................. 25
2.1 Device assignment
This manual is valid for the following devices:
• PSD1-SW1200 (2 A)
• PSD1-SW1300 (5 A)
• PSD1-M_1300 (5 A)
• PSD1-M_1400 (8 A)
• PSD1-M_1600 (15 A)
• PSD1-M_1800 (30A)
• PSD1-M_2220 (2 A + 2 A)
• PSD1-M_2330 (5 A + 5 A)
• PSD1-M_2440 (8 A + 8 A)
• PSD1-M_2630 (15 A + 5 A)
• PSD1-M_3222 (2 A + 2 A + 2 A)
• PSD1-M_3433 (8 A + 5 A + 5 A)
• PSD1-MWP010 (Mains module 10 kW)
• PSD1-MWP020 (Mains module 20 kW)
2.2 Scope of delivery
Included in delivery are mating connectors for:
PSD1-S
X17 (Push-in)
X51, X52, X63
Cable clamps for the motor cable in sizes D=7,9/9.5/11.1/12.7 mm
PSD1-M:
X17 / X21 (Push-in)
X45, X46, X48
Tin angle with screw terminals for motor and feedback cable
(see page 46)
PSD1-M_P:
X4 (Push-in)
X9, X40, X41
2.3 Type identification plate PSD1-S and PSD1-M with Safety
Option Board
The present device type is defined by the type specification plate (on the housing):
1 Order code of the device
2 Input voltage
3 Input Current
4 Serial Number
5
Output voltage
6 Output current
7 Output frequency
8 UL certification
(corresponding to the existing
logo)
9 Type of safety certification
2. Introduction