Parker PSD1-SW1200 - Overview Braking Resistors PSD1; Braking Resistor ACB-0004-01

192-011006N8 PSD1 Installation Guide
192-011006N8 2019-07 09.10.19 09:27 89 (109)
When mounting the brake resistor, please observe the expansion of the housing
of max. 0.85 mm / 100 mm due to heating (mounting with fixed and floating
bearings).
Mount the resistors in such a way that supply and extract air access is possible in
order to avoid heat accumulation. Resistors need to be protected by respective
protective measures.
The resistors with the thermal contact surface are to be mounted continuously to
a flat clamping area.
7.4.1. Overview Braking Resistors PSD1
Category
Specifications
Braking resistor (see
page 88)
Device
Nominal power
UL certification
ACB-0004-01 (51 Ω) (see
page 89)
PSD1-S_1200 / 1300
100 W
With UL
ACB-0005-01 (56 Ω) (see
page 90)
PSD1-S_1200 / 1300
120 W
With UL
ACB-0005-02 (56 Ω) (see
page 90)
PSD1-S_1200 / 1300
190 W
With UL
ACB-0001-01 (30 Ω) (see
page 90)
PSD1-M_P010
PSD1-M_P020 with 2x30 Ω parallel
400 W
2*400 W
With UL
ACB-0002-01 (15 Ω) (see
page 90)
PSD1-M_P010 with 2x15 Ω in series
PSD1-M_P020
2*400 W
400 W
With UL
ACB-0003-01 (15 Ω) (see
page 91)
PSD1-M_P020
1500 W
Without UL
7.4.2. Braking resistor ACB-0004-01
Pulse power (W) Tu ~ 40 °C
*referring to a cycle time
of120 s (reference value)
ED 6 %*
900
ED 15 %*
500
ED 25 %*
300
ED 40 %*
200
Nominal continuous output (W) Ta ~ 40°C
100
Nominal resistance value at 20°C
51 Ω
Nominal tolerance at 20°C
±10%
Type of protection (EN 60529) (in the
corresponding bolted state)
IP 65
Max. permitted operation voltage
UL 1000 V
Cooling
Natural convection
Housing temperature at a continuous nominal
output
Tu ~ 40 °C
approx. 180 °C
Electrical connection
2x AWG 14 / l=25 cm
Operating temperature range
-25 ... +40 °C
Test voltage
2.7 kV AC 1 s
Certification / Marking
UL; CSA
Weight
0.43 kg
Mounting positions
Scale drawing:
Stated in mm