Installation of the multi-axis system PSD1-M
44 (109) 192-011006N8 2019-07 09.10.19 09:27
Tolerances: DIN ISO 2768-f
5.3 Connector overview PSD1-M
In this chapter you can read about:
• Front view (PSD1-M) ................................................................................................................ 44
• View from below (PSD1-M) ...................................................................................................... 46
• View from above (PSD1-M) ...................................................................................................... 47
5.3.1. Front view (PSD1-M)
CAUTION: Risk of electric shock
Caution - Risk of electric shock!
Before wiring or loosening electrical connections please observe the
following:
• Risk of electric shock, disconnect power before removing cover resp.
disconnect the devices from the mains supply.
• Caution! Dangerous electrical voltage even after turning off the intermediate
capacitors:
Up to 3 minutes with PSD1-S and 10 minutes with PSD1-M after switching off
mains supply, dangerous voltages may still be present.
Please check that no voltages are present (<50 V) at the output terminals DC+
and DC- of PSD1-S: X63/3 & X63/5 and with PSD1-M: Bus HV DC - 3 & 5. rail.
To Next Page
Loading...
