Pco Edge 3.1 User Manual

72
A4.2 CAMERA LINK
INSTALLATION OF FRAME GRABBER A4.2.1
Instructions for installing and testing the Silicon Software
microEnable IV (ME4) Camera Link grabber card. This card is
required to be able to use a pco.edge with Camera Link interface.
Installation must be performed by a technician, because high
voltages can occur on the device.
ELECTRIC SHOCK WARNING DUE TO VOLTAGE PARTS INSIDE
Risk of injury due to electric shock.
 Always pull the main plug before opening the computer.
Please install the latest silicon software runtime package before
installing the hardware. (Download:
http://www.pco.de/support/)
When working on a 64 bit operating system, please make sure to
install the proper (64 bit) runtime when also a 64 bit application will be
operated. If the application is 32 bit, you need to install the 32 bit
runtime accordingly.
• Select full installation
• Let the program also update device drivers.
• Shutdown your computer, open the computer case and install
the grabber card
• The grabber card should be displayed within the device
manager. If the device is not shown this way, please reinstall the
SiliconSoftware device driver.
• After the installation, please start the program
microDiagnostics. (see next page)
1
1
2
4
5
2
3
5
4
3
WARNING

Pco Edge 3.1 Specifications

General

Brand	Pco
Model	Edge 3.1
Category	Digital Camera
Language	English