Pco Edge 3.1 User Manual

77
A4 INTERFACES
INSTALLATION OF FRAME GRABBER A4.3.1
Instructions for installing and testing the Silicon Software
microEnable V (ME5) Camera Link HS grabber card. This card is
required to be able to use a pco.edge with Camera Link HS interface.
Installation must be performed by a technician, because high
voltages can occur on the device.
ELECTRIC SHOCK WARNING DUE TO VOLTAGE PARTS INSIDE
Risk of injury due to electric shock.
 Always pull the main plug before opening the computer.
Please install the latest Silicon Software runtime package before
installing the hardware. (Download approved version from:
http://www.pco.de/support/)
When working on a 64 bit operating system, please make sure to
install the proper (64 bit) runtime when also a 64 bit application will be
operated. If the application is 32 bit, you need to install the 32 bit
runtime accordingly.
• Select full installation
• Let the program also update device drivers.
• Shutdown your computer, open the computer case and install
the frame grabber card
• The frame grabber card should be displayed within the device
manager. If the device is not shown this way, please reinstall the
SiliconSoftware device driver.
• After the installation, please start the program
microDiagnostics. (see next page)
1
1
2
4
5
2
3
5
4
3
WARNING

Pco Edge 3.1 Specifications

General

Brand	Pco
Model	Edge 3.1
Category	Digital Camera
Language	English