79
A4.4 USB 3.0
DRIVER INSTALLATION A4.4.1
Install PCO USB 3.0 Driver
For pco.edge USB 3.0 you always need to install the latest USB
Driver version. After these two screens the driver is completely
installed.
HARDWARE RECOMMENDATIONS
A4.4.2
The pco USB 3.0 interface is based on the Cypress EZ-USB FX31
device and it is compatible to pco software such as Camware and
SDK. To run a pco USB 3.0 camera successfully the user should
consider a number of important issues that are discussed in the
following chapters.
Motherboard and Chipset Configuration
It is recommended to use a Motherboard with a state of the art USB
3.0 host controller for the onboard USB 3.0 ports. The latest
generation of USB 3.0 xHCI host controllers manufactured by Intel,
Renesas (NEC), Fresco, Via Labs, ASMedia and Texas Instruments
Inc. (TI) are tested by Cypress Semiconductor Corporation. (see
Cypress EZ-USB® FX3TM SDK Release Notes, Version 1.2.3,
chapter 1.3). Currently pco recommends only motherboards with the
following onboard xHCI host controllers:
• Renesas/NEC μPD720202 Host Controller
• Intel® USB 3.0 eXtensible Host Controller
If the motherboard does not have an onboard USB 3.0 port or the
onboard USB 3.0 port does not work properly with a pco USB 3.0
camera, please use an independent PCIe USB 3.0 extension card.
In this case, pco recommends the following:
• DELOCK 89348 (U3-PCIE1XG202-10)
PCIe x1 Gen/V 2.0 (μPD720202 host controller)
(This board is sent with your pco.edge USB 3.0 camera system as standard)
• DELOCK 89325 (U3X4-PCIE4XE101)
PCIe x4 Gen/V 2.0 (μPD720202 host controller)
To Next Page
Loading...
Need help?
General
