Before Using Your Camera
1
17
Electronic Level Display
Press the u button while the status screen is displayed to
display the electronic level. A bar graph indicating the horizontal
camera angle appears at the bottom of the screen, and a bar
graph indicating the vertical camera angle appears on the right
side.
Example:
Memo
• The electronic level display will disappear if no operations are
made within 1 minute.
• If the camera angle cannot be detected, both ends and the center
of the bar graphs flash red.
• You can select the display setting with [Electronic Level Display] in
the [A3] menu. (z p.R19)
The camera changes the type of information display when you
press the M button during image playback.
Memo
• Press the u button, w button, or x button to switch
between the SD Memory Cards to play back.
• The information display that is shown first during playback is the
same as that of the last playback in the previous session. The
information display type differs depending on the setting of
[Memory] in the [A4] menu. (z p.R20)
• You can set whether to display the Bright/Dark Area warning with
[Playback Display Method] in the [Q1] menu. (z p.R22)
Horizontally and
vertically level (green)
Tilted 1.5° to the left (yellow)
Vertically level (green)
Outside horizontal level display (red)
Tilted 5° up (yellow)
Horizontally level (green)
Outside vertical level display (red)
Playback Mode
Standard display An image and guide indicators are displayed.
Histogram display
An image and its histogram (Brightness/RGB)
are displayed.
Detailed information
display
Detailed showing of how and when the image
was taken is displayed.
No info. display Only an image is displayed.
2000 F5.6
To Next Page
Loading...
Need help?
General
