31
Getting Started
2
Inserting/Removing the SD
Memory Card
This camera can use up to two commercially available SD
Memory Cards or SDHC Memory Cards (collectively referred to
as “SD Memory Cards” in this manual). Ideally you should use
a high-speed, large-capacity SD Memory Card.
Caution
• An SD Memory Card must be formatted with this camera before
use. (1 “Formatting an SD Memory Card” p.36)
1 Make sure that the camera is turned off.
2 Slide the card cover in the
direction of the arrow (1)
and then lift it to open (2).
3 Insert the card all the way
into the SD1 or SD2 slot with
the SD Memory Card label
facing toward the monitor.
Insert an SD Memory Card into one or
both of the SD1 and SD2 slots.
To remove the SD Memory Card, push
the card in again.
4 Close the card cover and then slide it in the
opposite direction of the arrow (1).
Caution
• Be sure to fully close the card cover. The camera will not turn on if
the card cover is open.
• Do not turn off the power or remove the SD Memory Card while the
card access lamp is lit.
Memo
• Refer to “Setting the File Format and Data Saving Method” (p.42)
for details on how to save data to the SD Memory Cards in the SD1
and SD2 slots.
2
1
e_kb487.book Page 31 Wednesday, December 8, 2010 9:49 AM
To Next Page
Loading...
Need help?
General
