43
Shooting Functions
3
2 Turn the S dial while pressing the x button.
Configure the setting for the SD Memory Card in the SD2 slot in the
same manner.
Caution
•
Depending on the setting and condition for storing the data, when one
or both of the SD Memory Cards become full and no more images can
be saved, an error message appears and the shutter locks.
• When [JPEG] or [RAW+] is set for both cards, the JPEG images
saved to both cards have the same [JPEG Recorded Pixels] and
[JPEG Quality] settings.
Memo
• You can check the data saving status for each slot on the status
screen (p.15), LCD panel (p.22) and in the viewfinder (p.20).
When [JPEG] is selected as the file format, set the recorded pixels
and quality level (
C
Best,
D
Better, and
E
Good). This
does not have to be set when [RAW] is selected as the file format.
Set the recorded pixels for M and S with [35. M and S Pixel
Resolution] in the [A5] menu. (z p.R35)
1 Turn the R dial while
pressing the w/x
button.
The setting changes in the following
sequence: LC (default setting),
LD, LE, MC, MD, ME,
SC, SD, SE.
Memo
• If you set [JPEG] or [RAW+] for both cards, when either the w or
x button is used to set the recorded pixels and quality level, both
cards will have the same settings.
JPEG Recorded Pixels/Quality
Level
Setting Recorded Pixels Pixels
L i 7264×5440
M
k 6528×4896
n 5376×4032
S
q 4224×3168
a 3072×2304
e_kb487.book Page 43 Wednesday, December 8, 2010 9:49 AM
To Next Page
Loading...
Need help?
General
