58
Shooting Functions
3
Flash Mode
1 Remove the hot shoe cover
of the camera.
2 Attach the flash and turn on the camera.
Memo
• Press the I button to discharge the flash in Modeling Flash or
Test Flash mode. Set this with [34. External Flash Discharge] in the
[A5] menu. (z p.R35)
You can connect a sync cord to the
X-sync socket on the camera.
Caution
• Do not use high-voltage or high-current external flashes. They may
cause the camera to malfunction.
• A flash with reversed polarity (the center of the hot shoe or sync
plug has a negative symbol) cannot be used, as this may damage
the camera or flash.
• Linked functions will not work.
• To prevent vignetting caused by Trailing Curtain Sync from
occurring, it is recommended to take a test shot using a shutter
speed one stop slower than the flash sync speed.
• The contact of the X-sync socket is not dust-proof or water-
resistant. Attach the provided Sync socket 2P cap when not in use.
The following flash modes are available. The flash modes that
are available differ depending on the exposure mode.
Attaching a Flash
Using a Sync Cord
Setting the Flash Mode
Flash Mode Available Exposure Modes
E Flash On
e/K/b/c/L/a/p/M
F Flash On+Red-eye Reduction
G Slow-speed Sync
e/K/c
H Slow-speed Sync+Red-eye
e_kb487.book Page 58 Wednesday, December 8, 2010 9:49 AM
To Next Page
Loading...
Need help?
General
