Perle IOLAN STS - Adding;Editing a Multihost Entry

129
Serial Port Profiles
Adding/Editing a Multihost Entry
When you click the Add or Edit button, the Host Entry window appears. The hosts in the multihost
list must already be defined (see
Host Table on page 88 to learn how to create a host). If you add a
host that was defined with its fully qualified domain name (FQDN), it must be resolvable by your
configured DNS server.
Configure the following parameters:
TCP Port Specify the TCP port that the IOLAN will use to communicate to the Primary
Host
.
Default: 0
Backup Host Specify a preconfigured host that the serial device will communicate to through
the IOLAN if the IOLAN cannot communicate with the Primary Host.
Default: None
TCP Port Specify the TCP port that the IOLAN will use to communicate to the Backup
Host
.
Default: 10000
Host Name Specify the preconfigured host that will be in the multihost list.
Default: None
TCP Port Specify the TCP port that the IOLAN will use to communicate to the Host.
Default: 0