Perle IOLAN STS - Accessing the IOLAN from the Network Users

RADIUS and TACACS+ 345
TACACS+
service = ppp
{
routing=x # x = true (Send and Listen)
# x = false (None)
addr = x.x.x.x # ipv4 or ipv6 addr
ppp-vj-slot-compression = x # x =true or false
callback-dialstring = x # x = number to callback on
}
service = ssh
{
addr = x.x.x.x # ipv4 or ipv6 addr
port = x # tcp_port #
}
service = ssl_raw
{
addr = x.x.x.x # ipv4 or ipv6 addr
port = x # tcp_port #
}
Accessing the IOLAN from the Network Users
This section describes the attributes which will be accepted by the IOLAN from a TACACS+ server
in response to an authentication request for Reverse Users. The TACACS+
service needs to be set
to
EXEC/raccess or just raccess on the well known port.
Name Value(s) Description
priv-lvl 12-15 (Admin)
8-11 (Normal)
4-7 (Restricted)
0-3 (Menu)
The IOLAN privilege level.
Perle_Line_Access_# # = port number
0 (Disabled)
1 (ReadWrite)
2 (ReadInput)
3 (ReadInputWrite)
4 (ReadOuptut)
5 (ReadOutputWrite)
6 (ReadOutputInput)
7 (ReadOuputWrite)
For the specified line, provides the User’s
Line Access rights.
timeout 0-4294967 Session timeout in seconds.
idletime 0-4294967 Idle timeout in seconds.
Perle_Clustered_Port_Access 0 (Disabled)
1 (Enabled)
Control access to clustered ports.