IOLAN SDS/SCS/STS User’s Guide, Version 3.6 31
Hardware and
Connectivity Chapter 2
2
Introduction
This chapter describes how to physically set up your IOLAN unit. It includes an overview of the
IOLAN hardware components and how to power up the IOLAN to make sure it works correctly.
IOLAN Components
What’s Included
The following components are included with your product:
z IOLAN unit
z External power supply (1-, 2-, and 4-port models only)
z Quick Start Guide (for I/O models, a soft copy exists on the CDROM)
z Warranty Card
z A CD-ROM containing documentation, firmware, configuration software, TruePort, etc.
z IOLAN models that have an RJ45 serial connector(s) come with an RJ45JDB9F adapter
Added components for rack mount models:
z 3’ CAT5 RJ45 Administration cable
z Rack mounting kit
z (SCS models only) IOLAN Cable Starter Kit (see Appendix H, Accessories on page 379 for
pinout diagrams).
What You Need to Supply
Before you can begin, you need to have the following:
z A serial cable(s) to connect serial devices to your IOLAN unit
z An Ethernet CAT5 10/100/1000BASE-T cable to connect the IOLAN unit to the network
Note:
SDS P (Power Over Ethernet) models and I/O models do not have an external power
supply.
To Next Page
Loading...
