Perle IOLAN STS - Advanced Tab Field Descriptions

155
Serial Port Profiles
Advanced Tab Field Descriptions
Configure the following parameters:
Success String String that is sent to the serial device when a connection succeeds.
Default: CONNECT <speed>, for example,
CONNECT 9600
Failure String String that is sent to the serial device when a connection fails.
Default: NO CARRIER
Numeric Codes When enabled, the connection status is sent to the connected device using the
following numeric codes:
z 0 OK
z 1 CONNECTED
z 2 RING
z 3 NO CARRIER
z 4 ERROR
z 6 ITERFACE DOWN
z 7 CONNECTION REFUSED
z 8 NO LISTNER
Default: Enabled
Echo characters in
command mode
When enabled, echoes back characters that are typed in (equivalent to
ATE0/ATE1 commands).
Default: Disabled
DTR Signal Always
On
Specify this option to make the DTR signal always act as a DTR signal.
Default: Enabled
DTR Signal Acts as
DCD
Specify this option to make the DTR signal always act as a DCD signal.
Default: Disabled