IOLAN+ Interface
60 IOLAN SDS/SCS/STS User’s Guide, Version 3.6
Changes to the IOLAN+ Interface
You should be aware that the following IOLAN+ configuration fields are no longer supported:
z You no longer have the option of selecting access, Authentication/Logging. Also, kill, reboot,
and
stats are not available.
z When you select port, the following fields are not available on the Port Setup Menu:
z User, Name—only when using LPD/LPR, Name no longer is used as the queue name
z Options, Rlogin/Telnet
z Options, Debug options
z Options, Hex data
z Options, Secure
z Keys, Sess
z Access, UDP Retries
z Access, Retry Interval
z Access, Authentication
** Administrator ** PORT SETUP MENU REMOTE-ADMIN
Hardware Flow ctrl Keys
Speed [9600 ] Flow ctrl [None ] Hot [^A] Intr [^C]
Parity [None ] Input Flow [Enabled ] Quit [^]] Kill [^\]
Bit [8] Output Flow [Enabled ] Del [^H] Sess N/A
Stop [1 ] Echo [^E]
Break [Disabled] IP Addresses
Monitor DSR [No ] Src [ ] Mask [ ]
Monitor DCD [No ] Dst [ ]
Interface [EIA-232] Access
User Options Access [Local ]
Name [abcd ] Keepalive [No ] UDP Retries N/A
Terminal type [dumb ] Rlogin/Telnet N/A Retry Interval N/A
TERM [ ] Debug options N/A Authentication N/A
Video pages [5] Map CR to CR LF [No ] Mode [Raw ]
CLI/Menu [CLI ] Hex data N/A Connection [None ]
Reset Term [No ] Secure N/A Host [ ]
MOTD [Yes ] Remote Port [0 ]
Local Port [10001]
________________________________________________________________________________
To Next Page
Loading...
