Sealing
48
Input of a welding distance of 1..99999mm.
With this function a welding distance up to a length of 99999mm (~ 100m) can be programmed.
After the entered distance has been covered, taking the other welding parameters into account,
the system switches to the next area or the program ends in the last area. The activated function
can be recognized in the editor by the entry in the function key .
Define subsequent program
This function determines whether the program starts again from the beginning after it has
been processed or whether another program is started afterwards. The program editor enters
the number of the start area here by default. This means that a processed program will start
again from the beginning.
Should the current program 5 be processed with e.g. Program 1, enter the desired program
number here:
The display shows P1 as the first area of a program.
To Next Page
Loading...