11 - 6
Input
CORRECTION VALUE STEPPING MOTOR
This function is used to correct the zero position of the stepping motor for
adjusting the fullness.
MOVE STEPPING MOTOR
With this function the stepping motor can be moved.
Clockwise direction
Anti-clockwise direction
CONTRAST SETTING OF DISPLAYE
On no account may the display be changed to such an extent, that it
is impossible to read it!
This function alters the contrast setting of the display.
SWITCH OUTPUTS
With this function the outputs can be set or reset,
See Chapter 13.10 Table of inputs and outputs
Output on
Output off
3
5
1
2
4
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
bdf
1- CORRECTION VALUE STEPPING MOTOR
2- MOVE STEPPING MOTOR
3- CONTRAST SETTING OF DISPLAY
4- SWITCH OUTPUTS
5- DISPLAY INPUTS/OUTPUTS
6- CARRY OUT COLD START
SERVICE
This function opens a menu for selecting service functions.
To Next Page
Loading...
