4:3
1a 1b 1c 2a
3
4
A
A CB
2b 2c 2d 2e
24
Sewing mode
Select a stitch
To select a stitch, touch the actual stitch in the stitch
selection area (3). You can scroll through the list of
stitches by touching the arrows at the right of the
stitch selection area (4). The number of the actual
subcategory is shown between the arrows (A).
You can also select a stitch from the selection menu
(24), see page 3:4.
Sewing recommendations (1)
Your machine automatically gives you
recommendations for the selected stitch.
1a) Presser foot recommendation
1b) *%5 system recommended
1c) Stabilizer recommended
Machine settings (2)
Some machine settings are indicated with a symbol
when activated in the settings menu.
2a) Set for twin needle
2b) Set for stitch width safety
2c) Set for dynamic spring foot free-motion
2d) Set for spring foot free-motion
2e) Set for sensormatic free-motion
Raise and lower the presser foot
Your machine features the automatic presser foot
up and extra lift button and the presser foot down
and pivot button.
To lower the presser foot, place the fabric under the
presser foot and press the presser foot down button
(A) or step on the foot control. To raise the presser
foot, press the presser foot up button (B) or press
the thread snips button (C) to cut needle and bobbin
thread and raise the foot. When the needle stops in
the down position, the presser foot raises to pivot
height.
You can also lower the presser foot and the needle
with your foot control. If you tap your foot control
once you will lower the presser foot. If you tap
the foot control a second time the needle will be
lowered into the fabric.
Note: With Needle down selected, when you stop sewing
and touch the presser foot up button the foot will raise
but the needle stays in the fabric. Touch presser foot up
again to raise the needle.
To Next Page
Loading...
