7:5
Embroidery mode - preparations
Slide on the hoop
Make sure that the accessory tray (only on the large
embroidery unit, type BE20) on the embroidery unit
is closed. Slide the hoop onto the embroidery unit
from front to back until it clicks into place.
The marked center point on the design should
match the starting point of the needle. If minor
adjustments are needed use the icons on the screen
(See chapter 8).
To remove the hoop from the embroidery arm,
press the grey button on the hoop connection
assembly and slide the hoop towards you.
To Next Page
Loading...
