5:3
Sewing mode Embroidery
mode
10
20
18
5
B
A
A
Sequencing
Open and exit sequencing
Sequencing can be used in both sewing mode
and in embroidery mode. To open, just touch the
sequencing symbol (A) on the option bar. To close
sequencing and sew or embroider your created
sequence, touch OK (20) in the top right corner.
Note: If sewing mode is active and your programmed
stitch is ready to be sewn, you can also close the active
function by pressing the foot control, or by pressing the
start/stop button.
Not all stitches are available to use in a sequence. If
you try to select an unavailable stitch, a pop-up will
notify you.
Create a sequence
To start creating a sequence, À nd the desired
stitch category by scrolling with the arrows at the
bottom of the stitch selection area or by opening the
selection menu (18). Touch a stitch in the selection
area to add it to the sequence.
To create a sequence from letters, open the selection
menu (18) and load the desired stitch font. In the
stitch selection area, touch the circles (B) to select
upper or lower case letters, normal or numbers and
special symbols.
The active position is marked by a cursor and the
selected stitch or letter will be marked in green.
Inserted stitches will be placed at the cursor
position. Only the selected stitch can be adjusted.
Move the cursor through the sequence using the
arrows (10). The number of the selected stitch and
total number of stitches in the sequence are shown
between the arrows.
Insert a stitch or letter
Move the cursor where you want to add a stitch or
letter. Select the desired stitch you want to insert. It
will be placed at the cursor position.
Adjust text and stitches
You can mirror, adjust length and width or change
the density or position of the selected stitch. The
adjustments work just like in sewing mode.
Delete a stitch or letter (5)
If you want to delete a stitch, move the cursor to the
stitch you want to delete and touch the delete icon.
Use the long touch function to delete the whole
sequence.
To Next Page
Loading...
